Automatic
cycle except for placement and removal of plastic plate.
Molds
a wide range of materials such as HDPE, PP, PMMA, ABS,
PET, PVC from 1mm to 10mm (1/16 " to 3/8 " ) thickness
depending on material type.
Optimized
heat distribution due to individual temperature
control of each zone of the oven. The quantity of zones
varies according to machine size.
Oven
is designed to allow thermal expansion and is made of
stainless steel to prevent oxidation when using PVC.
Instantaneous vacuum is obtained through a high outflow
pump attached to a vacuum tank.
Detaching device is adjusted by air pressure
and time. It is useful when the molding adheres to the
tool, mainly when using male tools.
Fast pneumatic movements due to the use of first-class
components.
Infrared sensor to measure the temperature
of the sheet during the heating time.
Rotation of frames uses an electric motor and a clutch
system.
Molding table height is adjustable according to the tool.
Pre-blowing
(billow).
Radial
fans to reduce cooling time
The
double furnace heats both sides of the plastic plate,
reducing the heating time and minimizing the difference
between the surface temperatures of each face. Because
it is designed as a rotating machine, the furnaces may
be turned on at each cycle, saving energy and increasing
productivity
High-capacity
PLC
with friendly interface. It controls the temperature in
the zones of the furnace, the heating and cooling times
and the temperature of the plastic during the heating
period, besides other functions. It has a memory for 20
tools including all temperatures, times and configuration
of each one.
Besides the molding area, it is possible to select optional
features to equip RV-2:
Catalytic
gas ovens to replace the conventional
furnaces. Because they are catalytic, they allow safer
operation and controlled heating temperatures.
